Diecast Crazy Forums banner
1 - 4 of 4 Posts

·
RIP Bigdog
Joined
·
2,539 Posts
Discussion Starter · #1 ·
Got one of my cars in this week and today went to take it out of the box to display and noticed the front wheel was off the car. When I first opened the box I noticed a pin rolling around, after unscrewing the car the front wheel feel out. Now my question to you all, how do go about removing the front end to replace the pin and wheel? I already have the body off the chassis but don't really see how to take the rest apart. Below is a photo of the car. Thanks

 

·
"For once, just shut up"
Joined
·
6,087 Posts
the front suspension has two screws...should be relatively simple on an ARC car...just need a similar arc to replace the entire front wheel assembly, pin and all. there is a short portion and a longer portion on that broken wheel... you SHOULD be able to replace it in the holes pretty simply. Flip the car over and look at it. You'll see the pins or pivot points on the chasis.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top